$44.95
The voltages on the secondary side of an ignition system are too high to be measured directly. To safely measure these signals, the Ignition Pickup TP-IP250 can be used.
The Ignition Pickup TP-IP250 is a capacitive secondary ignition pickup, which can be clamped around a spark plug wire. The pickup has a ground wire with a large alligator clip. The pickup is fitted with a male BNC terminal, a BNC to 4 mm banana converter is included to connect measure leads with banana terminals.
The table below shows detailed specifications of the Ignition Pickup TP-IP250.
Pickup |
|
|---|---|
| Connector | female BNC |
| Dimensions | |
| Length | 97 mm |
| Width | 25 mm |
| Height | 43 mm |
| Ground wire | 25 cm |
| Ground clamp | |
| Length | 75 mm |
| Width | 12 mm |
| Height | 40 mm |
| Clamping range | 20 mm |
| Weight | 48 g |
BNC to banana adapter |
|
| Connector | male BNC 2 x isolated 4 mm banana socket, red and black |
| Dimensions | |
| Length | 60 mm |
| Width | 30 mm |
| Height | 16 mm |
| Weight | 26 g |
Warning:The Ignition Pickup TP-IP250 is designed to be used in combination with an instrument with a differential input, like the Automotive Test Scope ATS5004D. Using it in combination with an oscilloscope with single ended inputs may cause a short circuit that can damage the scope and the car.
The Ignition Pickup TP-IP250 is delivered with:
| Amount | Item |
|---|---|
| 1 | Ignition Pickup TP-IP250 |
| 1 | BNC to banana adapter |
